Author Topic: Making a straight edge from an old surface plate  (Read 3969 times)

Offline Andrew Wildman

  • Full Member
  • ***
  • Posts: 167
  • Country: 00
Making a straight edge from an old surface plate
« on: July 24, 2017, 05:03:35 PM »
As part of my grinder rebuild I needed a dovetail straight edge.  I was loathed to mess with one of the camelbacks (non dovetail type) that I have and finding one used was not happening, so I made one from an old surface plate.  Here is a quick video showing the build:



 :D :D :D

Offline DMIOM

  • Hero Member
  • *****
  • Posts: 676
  • Country: gb
  • Isle of Man
Re: Making a straight edge from an old surface plate
« Reply #1 on: July 25, 2017, 01:57:32 AM »
Bravo Andrew - nice job!   Thanks for sharing

Dave

Offline Biggles

  • Full Member
  • ***
  • Posts: 236
  • Country: gb
Re: Making a straight edge from an old surface plate
« Reply #2 on: July 27, 2017, 01:43:46 AM »
Excellent Andrew

Offline PekkaNF

  • Hero Member
  • *****
  • Posts: 2523
  • Country: fi
Re: Making a straight edge from an old surface plate
« Reply #3 on: July 27, 2017, 10:16:42 AM »
Vey good. I may need to do something similat, just haven't found prefab. material.

You have other widgets in pipeline?

Pekka
« Last Edit: July 27, 2017, 11:58:17 PM by PekkaNF »

Offline Andrew Wildman

  • Full Member
  • ***
  • Posts: 167
  • Country: 00
Re: Making a straight edge from an old surface plate
« Reply #4 on: July 27, 2017, 10:49:54 AM »
 Other widgets: I have to measure the table dovetail and the carriage double bed way to ensure that are parallel, orthogonal etc. I have a few ideas how to do this involving indicators, squares and of course widgets!