Author Topic: Maximat V10  (Read 2667 times)

Offline prasad

  • Newbie
  • *
  • Posts: 1
Maximat V10
« on: September 06, 2014, 12:14:04 PM »
Hello Guys,

Do we have any owner of Maximat V10 lathe mill combo on this group? I need some advice. There is a Maximat V10 at Washington DC donated to Capital Astronomers and located in their telescope making workshop. Not many users. I had used this machine some two years ago. Yesterday I visited them and looked at this lathe. The manual they have is not clear on how to change gears for thread cutting. I searched the Internet and could not find any detailed manual for download. I am sharing a couple of photos of the lathe.

If someone can share it I would like to send a printed copy to NCA for use by any member who may like to use the lathe. It is nice place and I started off into hobby machining.

Thank you
Prasad
Wynnewood PA

Offline 75Plus

  • Hero Member
  • *****
  • Posts: 624
  • Country: us
Re: Maximat V10
« Reply #1 on: September 06, 2014, 08:27:52 PM »
One of our members, MikeA, has a V-10 that he overhauled. He may see your post and reply to it or you can look him up on the members list and send him a PM. He is located in NE Ohio.

I assume you saw this site while searching the web. http://www.lathes.co.uk/emco/page4.html

Joe