Author Topic: The Weston Bye Geneva Hours Clock circuitry  (Read 3575 times)

Offline Weston Bye

  • Jr. Member
  • **
  • Posts: 90
  • Country: 00
  • Grand Blanc, Michigan
The Weston Bye Geneva Hours Clock circuitry
« on: October 13, 2014, 04:08:28 PM »
Here is my latest project, running in the pages of Digital Machinist magazine.

 First, a closeup of the "clockworks". A 60:1 worm gear drives a horizontal shaft that carries the Geneva pinion that drives the 12:1 Geneva wheel for the hours, and a 1:1 spur gear to drive the minute hand.

I call it Geneva Hours because I used a Geneva mechanism to advance the hour hand.

Although I used CNC for many of the details, I designed the clock so that it could be built using manual machines.

The clock uses the same circuit board, with a few parts added, that I designed for the Magnetic Gear Clock.

The series will run 3-4 issues for the important details and possibly another dealing with surface treatments.

As a service to readers of Digital Machinist, I am again offering circuit boards, kits and assemblies.
Bare circuit board $15.00
Electronic parts + board $40.00
Assembled & tested $55.00

I also offer coil winding service, where readers mail me their machined bobbins and I wind the coils and add lead wires, and then mail them back.  The cost is $40.00 for the four coils.

All prices are postpaid in the U.S.

I can be contacted by e-mail at wcbye@sbcglobal.net

Weston Bye
Practitioner of the Electromechanical Arts.
author of The Mechatronist column
Digital Machinist magazine

Offline BillTodd

  • Hero Member
  • *****
  • Posts: 776
  • Country: 00
  • Colchester Essex (where the lathes were made)
Re: The Weston Bye Geneva Hours Clock circuitry
« Reply #1 on: November 24, 2014, 05:35:30 PM »
I like it :)  I like the idea that a 'clock' can be just a display (and perhaps a counter) for a electronic time keeper , thus avoiding the problem of accuracy without loosing the essential mechanical nature of a clock.

 :thumbup:
Bill