Author Topic: The basics  (Read 5396 times)

Offline PK

  • Full Member
  • ***
  • Posts: 202
  • Country: au
Re: The basics
« Reply #75 on: October 24, 2016, 06:15:36 AM »
so some flexability is required.
To reiterate. It isn't. There may be better ways, and they are all more work....

Offline efrench

  • Jr. Member
  • **
  • Posts: 79
Re: The basics
« Reply #76 on: October 25, 2016, 01:03:26 AM »
Thanks for the replys and warnings about the Probe Overshoot! As I am used to manually touching off the tool didn't realise that the Probe function in the controller will drive the tool into the tool height sensor and so some flexability is required.

I just use the "Painfully Slow" setting in the touch off routine  :coffee: