Author Topic: The basics  (Read 15292 times)

Offline PK

  • Sr. Member
  • ****
  • Posts: 294
  • Country: au
Re: The basics
« Reply #75 on: October 24, 2016, 06:15:36 AM »
so some flexability is required.
To reiterate. It isn't. There may be better ways, and they are all more work....

Online efrench

  • Full Member
  • ***
  • Posts: 113
Re: The basics
« Reply #76 on: October 25, 2016, 01:03:26 AM »
Thanks for the replys and warnings about the Probe Overshoot! As I am used to manually touching off the tool didn't realise that the Probe function in the controller will drive the tool into the tool height sensor and so some flexability is required.

I just use the "Painfully Slow" setting in the touch off routine  :coffee: