Author Topic: Low profile clamp for 4 Vertex RT  (Read 662 times)

Offline Chuck in E. TN

  • Hero Member
  • *****
  • Posts: 547
  • Country: us
  • USAF Retired
Low profile clamp for 4 Vertex RT
« on: November 29, 2016, 01:38:27 PM »
I want to make a couple of low profile clamps for my RT, as shown in the attached photo, to clamp my RT on my X2 mill, in the horizontal postion. I have 6061 aluminum, or I could make a pattern and cast it out of wheelium. I plan to put 3 bolt holes in it as shown in the picture.
Will either material be strong enough?
Any other suggestions on dimentions or features?
I have tried contacting the web site where I got the photo, but no response.

Chuck
« Last Edit: November 29, 2016, 02:08:02 PM by Chuck in E. TN »
Chuck in E. TN
Famous TN last words: "Hey ya'll, watch this..."
MicroMark 7x14, HF X2 mill, Green 4x6 saw. Harbor Freight 170A mig