Gallery, Projects and General > How do I??

Low profile clamp for 4” Vertex RT

(1/1)

Chuck in E. TN:
I want to make a couple of low profile clamps for my RT, as shown in the attached photo, to clamp my RT on my X2 mill, in the horizontal postion. I have 6061 aluminum, or I could make a pattern and cast it out of wheelium. I plan to put 3 bolt holes in it as shown in the picture.
Will either material be strong enough?
Any other suggestions on dimentions or features?
I have tried contacting the web site where I got the photo, but no response.

Chuck

Navigation

[0] Message Index