The Shop > Metal Stuff
How to sharpen carbide scraper?
PekkaNF:
I have Sandvik (and similar) carbide insert scraper.
I have been trying to find out how to sharpen them properly. I can find pretty good information about business end radius etc, but sharpening details evade my googlings.
I knw that the diamond disc is used to shape it and in the end it needs to be honed, but any furher details are mixed.
1: Would normal diamond cup wheel of maybe 120 grit work on shaping?
http://www.arceurotrade.co.uk/Catalogue/Diamond-Tools/Diamond-Grinding-Wheels/Diamond-Grinding-Wheels---45-Dish
2: Honing is bit more tricky. I don't have copper plate or such to make discs, but I have some cast iron I could charge it with diamond.
What grit?
What rpm for about 100 mm dia?
Pekka
chipenter:
I use one of those diamon disks on a bench grinder , and for honing I use a 600 grit diamond sharpening stone http://www.toolstation.com/shop/p56163?table=no , leaves a good finish .
PekkaNF:
Thank you.
I will buy one of those diamond cup wheels.
I have some diamond hones, manual ones, have to try some.
Honing is still mystery, I though I'll need something like this:
Pekka
Pete.:
http://www.ebay.co.uk/itm/152210190653
These will make your life easy. Use the rough one for setting the radius and the fine one for honing an edge.
chipenter:
It's the same principal as a wood chisel , ground and then a higher angle for honing then polish the flat to loose ant burr ,
Navigation
[0] Message Index
[#] Next page
Go to full version