The Shop > Metal Stuff
Sneaky trick to remove thread..
John Hill:
I needed to take the thread off the ends of some threaded rods that were too long for my lathe. I wanted to put 'ends' on the rods so that I could mount in bearings for my router table project..
This was a test piece whereas the rods I am using are 2 metres long and I need to do each end. This rattled a bit due to the loose fit of the hardware store nuts but I will be getting nylock nuts while I do the work pieces which I hope will dampen the rattle and get a little better finish.
Not perfect but maybe close enough!
John
PekkaNF:
Did you let the allthread to do "autofeed" :lol:
Pekka
sparky961:
Modify the nuts by cutting through in one place, and a shallow cut opposite that. You'll get a wonderful grip without damaging the threads. You can tap a longer piece and do the same thing for lathe work, but concentricity may not be perfect.
DMIOM:
John - I did something similar years ago to get beneath/remove the hardened threads on the end of a ballscrew. Not wanting to get grinding debris on the mill or lathe, I anchored an XY compound vice alongside a bench grinder and clamped the nut in the vice. Infeed towards the wheel was via the compound table, traverse and covering the circumference was via a cordless drill on the other end of the ballscrew.
Dave
John Hill:
Yes, I turned the rod through the nuts to feed the cut.
Navigation
[0] Message Index
[#] Next page
Go to full version