Author Topic: Small Boring Head  (Read 480 times)

Offline Metalman

  • Jr. Member
  • **
  • Posts: 29
Small Boring Head
« on: February 07, 2017, 03:30:33 PM »
My video this week is for a small boring head which I made to suit my lathe milling head ( http://www.homews.co.uk/page158.html ) It should also be suitable for any of the small milling machines, for which to my knowledge, there are few, if any, suitable commercial heads.

A link to the video can be found here,  http://www.homews.co.uk/page199.html

Next will be a series of  “how to” videos  showing how to use my grinding rests for various sharpening tasks, typically, end mills (both edges), boring tools and slitting saws.

Harold

Offline Will_D

  • Sr. Member
  • ****
  • Posts: 463
  • Country: ie
    • National Homebrew Club of Ireland
Re: Small Boring Head
« Reply #1 on: February 08, 2017, 08:14:27 AM »
Next will be a series of  “how to” videos  showing how to use my grinding rests for various sharpening tasks, typically, end mills (both edges), boring tools and slitting saws.

Harold
Thanks Harold, my grinding rest and accouterments are nearly completed
Engineer and Chemist to the NHC.ie
http://www.nationalhomebrewclub.ie/forum/