The Breakroom > The Water Cooler
How to make really crappy 3D prints
JayMcClellan:
I just saw this offer from banggood, looks like a fine way to make biodegradable items if you can stand the smell. Now I just need to find some #2 filament... :)
efrench:
Actually, the design of these hotends are so simple, the clones can actually work quite well.
JayMcClellan:
I don't doubt it, but I was amused specifically by the wording. Read carefully.
philf:
--- Quote from: JayMcClellan on March 24, 2017, 02:20:25 PM ---I don't doubt it, but I was amused specifically by the wording. Read carefully.
--- End quote ---
Re: How to make really crappy 3D prints.
0.4mm E3D-V6 Metal 3D Printer Exturder Nozzle.
:thumbup:
PekkaNF:
Few spelling mistakes normally does not make any difference in any other sphere than sosial media.
Spelling mistakes from chinese supplier hardly are "Unpresidented".
Pekka
Navigation
[0] Message Index
[#] Next page
Go to full version