Author Topic: 3D Printed Ball Nut for the Insane  (Read 4981 times)

Offline tom osselton

  • Hero Member
  • *****
  • Posts: 816
  • Country: ca
Re: 3D Printed Ball Nut for the Insane
« Reply #25 on: August 28, 2016, 04:20:27 PM »
Looks like you are one short!   :beer:

Offline Joules

  • Hero Member
  • *****
  • Posts: 840
  • Country: gb
Re: 3D Printed Ball Nut for the Insane
« Reply #26 on: August 28, 2016, 04:23:42 PM »
I think that was the Ex's intention too....
Just get doing and make swarf, you can decide what its going to be later.   :thumbup:

Offline PK

  • Sr. Member
  • ****
  • Posts: 261
  • Country: au
Re: 3D Printed Ball Nut for the Insane
« Reply #27 on: August 28, 2016, 04:25:42 PM »
You got 2 sizes?
Every second ball in a ball nut is a metric poofteenth smaller. This allows it to act as an idler between the load bearing balls.

Offline Joules

  • Hero Member
  • *****
  • Posts: 840
  • Country: gb
Re: 3D Printed Ball Nut for the Insane
« Reply #28 on: August 28, 2016, 04:31:48 PM »
 :palm:  Oh no.....

I'll widen the raceway every 3mm, that way each one can be alternately idle.
Just get doing and make swarf, you can decide what its going to be later.   :thumbup:

Offline Joules

  • Hero Member
  • *****
  • Posts: 840
  • Country: gb
Re: 3D Printed Ball Nut for the Insane
« Reply #29 on: August 28, 2016, 04:44:50 PM »
 :lol:   PK, I had to look that up as I thought you were pulling my plonker....

Well friction will take care of itself as the nut heats up.
Just get doing and make swarf, you can decide what its going to be later.   :thumbup:

Online awemawson

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 5359
  • Country: gb
  • East Sussex, UK
Re: 3D Printed Ball Nut for the Insane
« Reply #30 on: June 04, 2017, 05:29:46 AM »
Resurrecting an old post here, but where are the pictures of the final result Joules  :scratch:
Andrew Mawson
East Sussex