Author Topic: Manual machine section on MadModder?  (Read 355 times)

Offline Symon

  • Jr. Member
  • **
  • Posts: 50
  • Country: gb
Manual machine section on MadModder?
« on: April 08, 2017, 06:19:40 PM »
Hi guys,

I see there's a CNC section to cover CNC lathes, millers etc...but can't find a manual machine section.

Where would be the best place to post, say, an old milling machine's rise to mint, err, ness? Is this place mainly CNC stuff?

Ta :)

Offline Joules

  • Hero Member
  • *****
  • Posts: 845
  • Country: gb
Re: Manual machine section on MadModder?
« Reply #1 on: April 08, 2017, 06:28:46 PM »
Next section down, Tools for manual stuff etc.  Though no rigid classes for things as it might be a project you have or just show what your up to in the gallery.

Or confectionary section if it's truly mint and sweet.   :drool:
Just get doing and make swarf, you can decide what its going to be later.   :thumbup:

Offline Symon

  • Jr. Member
  • **
  • Posts: 50
  • Country: gb
Re: Manual machine section on MadModder?
« Reply #2 on: April 08, 2017, 06:35:05 PM »
:thumbup:

"Tools of the trade. Discuss tools, machines, etc here. Got a question, ask"

:doh: I must have read that so many times and didn't even register it :doh:

Would just like to post an extensive tear-down thread on my Archdale. There's virtually no useful information (online) about these things and thought, as I got a lovely welcome here, it would be a good place to publish it here. Get more traffic etc :) Well, maybe a few more visits.

It'll be a step-by-step jobbie and I've already got a boat load of images (hosted on imgur.com as it's the best - not horrific like photobucket and it's data hogging adverts).