Gallery, Projects and General > Neat Stuff

These guys are definitely MAD

(1/2) > >>

Brass_Machine:
Interesting reading/viewing

Make it Extreme


Eric

awemawson:
I bet that that's exhausting to pedal, with a single ratio  :bugeye:

I've seen their tube cutter somewhere on the web - it was briefly seen in the video.

mattinker:
They've made a lot of interesting things!

Ginger Nut:

--- Quote from: Brass_Machine on April 11, 2017, 09:17:04 AM ---Interesting reading/viewing

Make it Extreme


Eric

--- End quote ---

Thanks for sharing I went on to check out this   :jaw:

PekkaNF:
Thank you, these are inspirational.

Like the speed of video, they don't compete with this video:


I did not like the bike episode. Bozo was blocking the trafic. But I like the rough-and-ready approach.

I don't get this "exreme" part at all.

That tube notcher has it's merits. Two things irks me there.

1: The plasma cable bundle exits from the shaft axially. Every design engineer knows that you don't twist cable/hose anything like that. Speicially hydrauli hoses or any other having a reinforcemet. You have to have the cable exiting axially radially and have it coil such a way that minimum bending is not exceeded. It would had only a little imact on design. Bit like cable drum on extension cable.

2: Wiper motors...ok to make proof of concept, but although some are legendary strong (some are even used in MIG wire feeders), generally they donät take much side load. Then they put the motor righ on harm's way.

Navigation

[0] Message Index

[#] Next page