Gallery, Projects and General > How do I??
Best adhesive to stick a magnet to a shaft - tacho project
paulmo101:
Hi
Still gathering information for my tacho project and I`m wondering what is the best adhesive to stick the magnet (trigger) to a shaft? The shaft will be in the headstock of my lathe so I wouldn`t want the magnet to come adrift when the lathe is turning I was considering 2 part epoxy, bearing retainer, chemical metal any other suggestions welcome. I was also going to cover the magnet with a strong (gorilla tape) duck type tape wrapped around the shaft and back onto its self as a belt and braces approach.
Thanks for reading
Ed ke6bnl:
Bill Smith IC-2000 might be a good choice
paulmo101:
Hi Ed
thanks for the reply - never heard of it but I will have a google
Cheers
Paul
seadog:
I just popped mine on the shaft letting physics do the holding, I've not had a problem and have run it above 2000rpm.
It depends on the diameter of the shaft. At a guess it's it's around 2-1/4" on my Boxford.
nrml:
3M VHB tape is what I would use. You can always apply a broad elastic band on top as belt and braces. A condom with the end cut off applied over the shaft and magnet (no pun intended) several times would do the job.
Navigation
[0] Message Index
[#] Next page
Go to full version