Gallery, Projects and General > Project Logs
Quick Change Toolpost Build
(1/1)
thecogwheel:
I completed my quick change tool post based on Metal Lathe Accessories' MLA-23 toolpost last week. It was scaled down for the 8" swing on the Schaublin 102. The original design might have been a bit large being designed for 9"-12" lathes, although it may have worked. I made a number of other changes as well.
Bits and pieces:
Here is the build video of it (you may want to watch it in Youtube as it will give a bigger picture):
https://www.youtube.com/watch?v=8d7xY4UNGAg
Now onto the next build. :proj:
SwarfnStuff:
Thanks for posting,
Well worth a look and just maybe I will make one with a further mod to suit my 7X. At the moment I am using one that is the aluminium, piston type and ok for light cuts. I see this design should hold the tool holder more securely plus it brings the tool back inside the top slide base rather than the usual overhang.
Thanks again.
John B
krv3000:
hi a job well dune
TURK122:
I'm in the process of making this out of 316l stainless steel
Sent from my SM-N910F using Tapatalk
Navigation
[0] Message Index
Go to full version