Home Base > Introductions

Hello

(1/2) > >>

JRow16:
 :wave: I've been reading this forum and have realised that I'm a beginner even though I've been using a micro mill for a couple of years :D.
Ive been scaffolding for the past 3 decades and I'm about to go into semi retirement. That should give me more time to tinker.
I've been using a sieg xl1 and a tiny proxxon but I am planning on buying a bigger mill, probably a sieg sx2.7.
Ive also tried a bit of home anodising with mixed results and hope to improve on this.

awemawson:
Welcome aboard JRow16  :thumbup:

We all have to start somewhere - none of us were born with machining experience. Many here will offer you lots of good advice - you only have to ask. Remember - the only silly question is the one that you DON'T ask

mexican jon:
Welcome Aboard JRow16  :wave:  :wave:

krv3000:
hi and welcome

Mike E.:
Hello, and Welcome !

Navigation

[0] Message Index

[#] Next page