The Shop > Electronics & IC Programing
Soft Start for Warco VMC motor
JerryNotts:
I have a VMC which always starts by going from 0 rpm to full revs almost instantaneously. This is accompanied by the whole machine rocking an almost imperceptible amount. If nothing else it makes me jump in surprise the first time I start it in any session.
Can anyone suggest a mod to make it 'soft start'? Short of installing a VFD. :zap:
Jerry
JerryNotts:
Aha. Perhaps the silence on this subject indicates that I might be on a loser!
I'll have to look seriously at a VFD system then.
Jerry :bang:
John Rudd:
First thing I did with my 626 was junk the oem motor in favour of a 3 ph and vfd.....
Will_D:
Try using a 3kw dimmer switch. We use them on our boilers (homebrew) but also I have used it to control a vacuum cleaner motor. They are very cheap on ebay . Worth a try
John Rudd:
Dimmer switches use a triac or scr and as far as I know are not suitable for induction type motors as per the vmc.
I stand to be corrected of course.....
Navigation
[0] Message Index
[#] Next page
Go to full version