Author Topic: A little shop cleaning.  (Read 1081 times)

Offline Doc

  • Sr. Member
  • ****
  • Posts: 419
  • Country: us
  • Old but still usefull (I hope) ?
A little shop cleaning.
« on: September 12, 2017, 07:00:53 PM »
Last weekends project.


<a href="http://www.youtube.com/watch?v=ERI5E9BZyp4" target="_blank">http://www.youtube.com/watch?v=ERI5E9BZyp4</a>
George

Offline Mike E.

  • Jr. Member
  • **
  • Posts: 31
  • Country: us
Re: A little shop cleaning.
« Reply #1 on: September 13, 2017, 06:59:33 AM »
Nice garage you have there Doc.  :thumbup:
Mike

California & Wales  - Home, & Home Away

Offline howsitwork?

  • Sr. Member
  • ****
  • Posts: 261
Re: A little shop cleaning.
« Reply #2 on: September 19, 2017, 05:35:29 PM »
Nice .
I painted my floor in workshop and gamlrage but the drive gravel and cars have removed a fair bit of the surface paint , over the last 18 years. Just can't face moving all the gear out to re do .

Next time I'll try epoxy paint I think. Anyone got thoughts on the epoxy versions?

Course given our weather it takes days to dry.....

Ian

Offline tom osselton

  • Hero Member
  • *****
  • Posts: 851
  • Country: ca
Re: A little shop cleaning.
« Reply #3 on: September 19, 2017, 07:15:44 PM »
Looking good I'm going the other route last year I had the exterior and roof done this year were doing the ceilings, insulating and putting osb plywood on the walls! There is a hell of a lot of shifting the same thing from one spot to another while clearing unwanted junk!

Offline Doc

  • Sr. Member
  • ****
  • Posts: 419
  • Country: us
  • Old but still usefull (I hope) ?
Re: A little shop cleaning.
« Reply #4 on: September 20, 2017, 01:19:45 PM »
 My shop is fully insulated and heated in the winter. I went with sheetrock when I did mine. I did catch a lot of flack about not using osb board but sheetrock was a lot cheaper and it doesn't go all the way to the floor. When I had it built I had about a half block above the floor. I have not been disappointed with making that decision.  I do eventually want to put a wall dividing it in half once I get rid of the Eldorado that sits in the corner. That will give me a shop about 28'x20' room for more machinery ;) Anyway thanks for the comments guys!! 
George

Offline Biggles

  • Full Member
  • ***
  • Posts: 215
  • Country: gb
Re: A little shop cleaning.
« Reply #5 on: September 22, 2017, 12:55:39 AM »
Nice one George,  I like your administrative support!  :lol:

Offline Doc

  • Sr. Member
  • ****
  • Posts: 419
  • Country: us
  • Old but still usefull (I hope) ?
Re: A little shop cleaning.
« Reply #6 on: September 22, 2017, 08:16:55 AM »
Hahaha
 She is always a good sport and is there to help.
   
     Unfortunately we did park n it a little too soon so we have spots that came up where the tires set. S I will redo those spots again and wait a little longer this time.
George