The Shop > CNC
cnc to pwm servo bob
(1/1)
BillTodd:
Inspired by joules' cnc thead, i thought I'd ask here about this…
Anyone know or have experience with a breakout board sthat will drive pwm servo amps (i.e. takes input from mach or linuxcnc, outputs pwm control to servo amp and reads quadrature from encoders)
I have set of servo motors and amps (glentec) but no means to control them .
The only thing i can find that might be suitable is. pico board fron the usa , but it is an expensive thing to experiment with.
Thoughts?
PK:
We use one of the Mesa boards http://www.mesanet.com/ with linuxcnc and our own amps on this:
A recent experience where I tried to build a servo system around some parts that I already had (in this case a couple of motors) taught me that it's cheaper just to buy a complete AC brushless kit .
YMMV
PK
Navigation
[0] Message Index
Go to full version