Author Topic: 4 jaw as a 3 jaw  (Read 1252 times)

Offline chipenter

  • Hero Member
  • *****
  • Posts: 735
  • Country: gb
4 jaw as a 3 jaw
« on: November 11, 2017, 10:06:03 AM »
I was gifted a Stuart 7A that had been abandoned , turning the crank shaft was a problem holding it to turn the big end , to get the 3/8" offset went pased the jaws so I just used 3 , I am shure I am not the first to do this but felt it was worth passing on .
Jeff

Online Pete.

  • Hero Member
  • *****
  • Posts: 806
  • Country: gb
Re: 4 jaw as a 3 jaw
« Reply #1 on: November 11, 2017, 10:13:50 AM »
I've done it in a pinch, but a better way would be to turn a split collar say 1" OD so you can pinch the small journal and still get 4 jaws on the collar.

Offline Meldonmech

  • Hero Member
  • *****
  • Posts: 906
Re: 4 jaw as a 3 jaw
« Reply #2 on: November 19, 2017, 10:30:56 AM »
 
 Hi Guys
                 I agree, with Pete and use a split collar. I keep various sizes of split collars, and some blanks to make specials.

                                                                  Cheers David

Offline mechman48

  • Sr. Member
  • ****
  • Posts: 322
  • Country: gb
Re: 4 jaw as a 3 jaw
« Reply #3 on: December 02, 2017, 10:57:35 AM »

 Hi Guys
                 I agree, with Pete and use a split collar. I keep various sizes of split collars, and some blanks to make specials.

                                                                  Cheers David

same here, much easier, I have a couple of odd ball collars ...somewhere... :scratch:
George.


Always look on the bright side of life, & remember.. KISS..' Keep It Simple Stupid'