The Shop > Tools

Chester Cub 630/ Warco GH750

(1/1)

martin33100:
Hi, I am looking for a small lathe for hobby use at home and ideally a gap bed.
I have considered the usual M300 or Bantam/Student.
I have just been offered a mint Chester Cub (same as a Warco gh750) that came out of a school, just wondered if anyone has had any experience with these machines?.
My workshop is long but only 2M wide so I don't really want a very deep lathe, for reference a M300 is about 300mm deeper than the Cub due to the swarf tray and coolant pump.
Any advice will be greatly appreciated.

This is the Cub that came out of a school:-

chipenter:
Have a look at the Grizzly web site for there equivelent and dowload the manual , Doc has a similar lathe look at his vidios to .

martin33100:

--- Quote from: chipenter on December 13, 2017, 02:21:49 PM ---Have a look at the Grizzly web site for there equivelent and dowload the manual , Doc has a similar lathe look at his vidios to .

--- End quote ---
Thanks for the info, I only joined the forum today so how do I find Doc's videos?

Spurry:
On home page tap the Members tag
Drop down tag - Search for member
Type in Doc
That should show his last posting.
If that's not what you need/want go to his profile and examine Posts
HTH
Pete

Navigation

[0] Message Index