Author Topic: cros slide nut  (Read 4281 times)

Offline krv3000

  • Hero Member
  • *****
  • Posts: 2183
  • Country: gb
cros slide nut
« on: October 24, 2011, 06:22:25 PM »
HI all well if you all remember the one on my lathe was broken sorrey no pics of the making of the new one i will tel you haw i mad it  i had a nice bit of bronse bare that i cut a lump off sqerd this off in the 4 jaw chuck then ofset it to turn the monting post drilld and tapt m6 then set it up on center to drill and tap m8 by 1mm pich left hand thred and all is well her issum pics of the old one