Author Topic: My Grizzly Mill G0619  (Read 6391 times)

Offline norman

  • Jr. Member
  • **
  • Posts: 11
My Grizzly Mill G0619
« on: November 24, 2011, 06:41:20 PM »
I bought the mill 10-21-2011. I built the stand from 2" sq. tubing.For the mill added a table power feed and a Dro Pros  electronica el400 dro. This is quite a big change from the Gingery metal mill I built, which now lives on the bottom of the mill stand ready for use if I happen to want to use it.



You can just see the G0602 lathe to the left and the Sears 6" lathe behind the mill.

here's the start of the stand

finished stand with most of my toys close by.

Offline Bernd

  • Madmodder Committee
  • Hero Member
  • *****
  • Posts: 3688
  • Country: us
  • 1915 C Cab
    • Kingstone Model Works
Re: My Grizzly Mill G0619
« Reply #1 on: November 24, 2011, 07:05:20 PM »
A very well and nice organized shop if I may say so.

I was orginally going to get that mill next that you have, but instead found a nice Bridgeport instead. It now resides in my basement.

Bernd
Route of the Black Diamonds