Author Topic: Potty Mill Engine  (Read 6642 times)

Offline sbwhart

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 3530
  • Country: gb
  • Smile, Be Happy, Have Fun and Rock Until you Drop
Potty Mill Engine
« on: January 26, 2013, 04:25:51 AM »
Just finished drawing up a simple mill engine, I've tried to design it so that it can be made using a lathe and a drill, no milling is required.

I've also tried to make it so that the cylinder can be used in other engine configurations.

I wont be making this engine for quite some time as I'm going to be concentrating on other things but if any one wants a PDF copy of the drawing just send me a PM with yur email adress and I'll send them a copy.

Attached is the assembly drawing

Stew
A little bit of clearance never got in the road
 :wave:

Location:- Crewe Cheshire

Offline Stilldrillin

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 4972
  • Country: gb
  • Staveley, Derbyshire. England.
Re: Potty Mill Engine
« Reply #1 on: January 26, 2013, 08:07:09 AM »
Thanks Stew!  :beer:

I reckon I could manage to build one of those, eventually.......  :thumbup:

Good luck, with your, "other things".  :)

David D
David.

Still drilling holes... Sometimes, in the right place!

Still modifying bits of metal... Occasionally, making an improvement!

Offline John Rudd

  • Hero Member
  • *****
  • Posts: 2525
  • Country: gb
Re: Potty Mill Engine
« Reply #2 on: January 26, 2013, 12:20:15 PM »
I'd love to build one too...pm sent.

Thanks Stew...
eccentric millionaire financed by 'er indoors
Location:  Backworth Newcastle

Skype: chippiejnr