MadModder
The Craftmans Shop => New from Old => Topic started by: smiffy on September 19, 2016, 03:02:35 PM
-
Another job today . This one is a front axle from a 1929 John Deere tractor . It had already been bored out and had a bronze bush inserted but it had been badly done and was not squared to the axle It is realy a bit too big for this machine which is a Arboga milling machine so had to use a piece of channel to make the table longer , bored out the bush and fitted 2 steel backed glacier bushes . It looks a lot better now