MadModder

Gallery, Projects and General => Gallery => Topic started by: DaveS on February 21, 2017, 05:08:34 PM

Title: Update on introduction
Post by: DaveS on February 21, 2017, 05:08:34 PM

Just a couple of photos of some of the larger projects. Cut off saw is by the design by Myford Boy with alterations, the picture would have looked better if the polishing dept was removed from under the vice handle. Secondly the S50, my first attempt at proper machining which I was quite pleased about especially the brass cylinder jacket which I formed from a scrap piece of brass plate.

Title: Re: Update on introduction
Post by: awemawson on February 21, 2017, 05:14:45 PM

I bet that saw saves you some elbow grease   :clap:

Elegant looking engine - have you had it running ?

Title: Re: Update on introduction
Post by: DaveS on February 21, 2017, 06:20:33 PM

Yes it has run but not on steam only XXX



Dave