Author Topic: Hello again...  (Read 3065 times)

Offline cloud9rich

  • Jr. Member
  • **
  • Posts: 5
  • Country: gb
  • Myford Diamond 10 lathe owner
Hello again...
« on: November 05, 2014, 07:44:21 PM »
I'm logged back in after too long away :clap:  I have just bought a Hobbymat lathe, actually badged as a Soupe SD300 after buggering about with allsorts for too long.  This is a cracker, almost unmarked and little used.  After a bit of cleaning up and adjusting it is so tight and sure, I'm all fired up again!  And I find John Mills (doubleboost) on here too, one of my very favourite YT sources of info and entertainment.  So,lots to learn and talk about.  :beer:  Cheers, Rich :wave:
Tomorrow - who knows, yesterday - who cares

Offline dawesy

  • Sr. Member
  • ****
  • Posts: 252
  • Country: gb
Re: Hello again...
« Reply #1 on: November 06, 2014, 03:33:32 AM »
Hi rich. Welcome back :)
Lee.
wishing my workshop was larger :(

Offline DavidA

  • Hero Member
  • *****
  • Posts: 1219
  • Country: gb
Re: Hello again...
« Reply #2 on: November 06, 2014, 07:18:35 AM »
Good to see you around again.

And don't forget the pictures.

Dave. :wave:

Offline Meldonmech

  • Hero Member
  • *****
  • Posts: 933
Re: Hello again...
« Reply #3 on: November 06, 2014, 08:08:02 AM »
 Hi

                                         Welcome back

                                                                Good Luck with the new Lathe
                                                                                                                       Cheers David

Offline krv3000

  • Hero Member
  • *****
  • Posts: 2183
  • Country: gb
Re: Hello again...
« Reply #4 on: November 07, 2014, 04:14:32 PM »
hi and welcume

Offline spuddevans

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 1618
  • Country: 00
  • Portadown, Northern Ireland
    • My Photo website
Re: Hello again...
« Reply #5 on: November 08, 2014, 08:41:18 AM »
Hello and welcome

Tim
Measure with a micrometer, mark with chalk, cut with an axe  -  MI0TME