« previous next »
Pages: [1]   Go Down

Author Topic: Elliot M10 shaper  (Read 3046 times)

Offline kayzed1

  • Sr. Member
  • ****
  • Posts: 294
Elliot M10 shaper
« on: January 13, 2015, 08:59:42 AM »
The eldest lad has an Elliot M3 shaper in his garage that is never used and he is going to sell it, so i told him not to sell at the moment until i have told you guys. I thought it may be nice to see it used by a fellow Modder. Contact me for his tele number...UK only :doh:
Lyn.

PS: Ex school so not a lot of work done on it.
« Last Edit: January 13, 2015, 04:11:02 PM by kayzed1 »
Logged

Offline mattinker

  • Hero Member
  • *****
  • Posts: 1316
  • Country: fr
Re: Elliot M3 Shaper
« Reply #1 on: January 13, 2015, 12:20:14 PM »
What's an M3? I thought that the number stood for the cube in inches that an Eliot shaper can cut! My Elliot is an M10, it can cut a ten" cube.

Regards, Matthew.
Logged

Offline Kjelle

  • Full Member
  • ***
  • Posts: 176
  • Country: se
Re: Elliot M3 Shaper
« Reply #2 on: January 13, 2015, 01:54:32 PM »
 :worthless:

Looked at Lathes, but the smallest was the 10M... If it's smaller please post weight too!

Kjelle
Logged

Offline David Jupp

  • Sr. Member
  • ****
  • Posts: 308
  • Country: gb
  • Teesside - UK
Re: Elliot M3 Shaper
« Reply #3 on: January 13, 2015, 02:12:10 PM »
I think it's a 10 Mk 3 - I'd love to have one, but realistically can't justify it.
Logged

Offline kayzed1

  • Sr. Member
  • ****
  • Posts: 294
Re: Elliot M3 Shaper
« Reply #4 on: January 13, 2015, 03:52:13 PM »
Just asked the lad and YES it is the M 10 :doh:
Logged
Pages: [1]   Go Up
« previous next »