Gallery, Projects and General > Project Logs
Coke Forge Build
RobWilson:
Hi Chaps :wave:
Just thought I would show you lot what I have been up to ,I decided after about 20 years of collecting blacksmithing tools that it was about time I made a start on building a forge :dremel:
Some of the gear I have collected over the years .
The forge will be located in this corner of the workshop (plate and sheet material will be relocated ) when built .
The forge stand was made from some scrap I recycled from work , it was an old batter change over station .
This was cut up and welded to make the stand .
Then the hearth was made up from a bit 3/8 plate .600MM X 600MM is as large a hearth as I can fit in space available .
Next up the Fire pot , this was made up of 1/2" plate .
Rob
John Rudd:
Nice job there Rob, up to your usual standard.... :bow: :dremel:
What you using for a blower? Your lass's old hair drier ....?lol :lol:
Think I might have some part used BBQ charcoal you can have..too... :loco:
RobWilson:
:lol: :lol: Nope I was hoping to borrow your hair dryer John :poke:
Blower Design (PREVIEW ) :)
Rob :dremel:
awemawson:
A bit flimsy isn't it Rob - only 1/2" plate for the fire box :lol:
Arbalist:
Half inch plate plate is fairly common on builds over on IForgeIron, some folks prefer 5/8" though! :D
Navigation
[0] Message Index
[#] Next page
Go to full version