Thanks Joe, I'm definitely learning from yours!
I'm far from expert at this but luckily, the difference between being really good at it and not so good is, I think, just how quickly you get the results you want. I bet a professional can get to the level I reach in a quarter the time, and probably carries on from there.
Anyway, the things I find helps are pretty simple. Don't go lightly to start with, dig in. There is a great temptation to scrape lightly to start and take every last bit of blue off. That's kind of finicky, and it means many, many more rubs and scrapes.
I'm a lot more ruthless now than I was at the start of the bed scraping. There are a lot of good videos for scraping, and one of them shows a pro with a scraper taking strokes that raise smoke each time!
Towards the end, you can start to get more careful and use lighter pressure. I find this time around that at the end of the day today I was a lot further along with the lathe ways than I was after 3 days on the lathe bed.
Stoning the work to remove burrs is important, as well as frequent sharpening (at least with a HSS scraper). Also being extremely careful not to get any tiny chips or debris clinging to the work when bringing it over to rub on the surface plate. Any speck on the plate ruins the rub. Bits of scraping get under the bed each time you work on it. You have to brush the bench top off, and the work each time before rubbing it. But basically it's just a lot of time and repetition. Oh, imperative to wear gloves -- at least for me. I also frequently clean the plate with kerosene and re-ink.
Here's how far I got at the end of the day today. Quite a lot of progress for me compared to last go around:
![](http://vtsteam.com/Lathe/Scraping2.jpg)