Author Topic: DDCSV1.1 4 Axis controller  (Read 307174 times)

Offline Muzzerboy

  • Jr. Member
  • **
  • Posts: 50
  • Country: gb
    • The Mighty Shiz
Re: DDCSV1.1 4 Axis controller
« Reply #1000 on: October 21, 2020, 03:04:58 PM »
This may have been asked before but the DDSV doesn't (yet) support lathe functions natively, so what is considered the next best option for a self contained controller for a lathe conversion? I'm sort of thinking LinuxCNC but it would have been really nice if the DDSV were available in a lathe flavour.

I'm familiar with the Newker / Newkye / SZGH / Adtech options which don't appeal TBH (Chinglish fatigue!). Wondered if there was something in between. The downside of LinuxCNC is that I'd soon have torn all my hair out and there's not as much left as I'd like as it is.

Offline kankarrio

  • Jr. Member
  • **
  • Posts: 5
Re: DDCSV1.1 4 Axis controller
« Reply #1001 on: October 24, 2020, 11:43:24 AM »
Thank you very much for your answers :beer:


as soon as work allows me to install the update to pandora

I wish I had the ddcsv the lathe option, it would also save me a lot of trouble

PS- I express myself very badly in English, I use google translator, I apologize if my words are confusing




Offline WeldingRod

  • Sr. Member
  • ****
  • Posts: 314
Re: DDCSV1.1 4 Axis controller
« Reply #1002 on: October 27, 2020, 10:23:13 PM »
Are we pretty sure the 3.1 firmware works on the 4 axis 2.1 or 1.1 hardware?  Or is the only change in the hardware a new silkscreen?

My mad modder version has started stalling on gcode files for no clear reason.  I think it's time for a re-brain.  Mwah-ha-ha!

Sent from my SM-G892A using Tapatalk


Offline WeldingRod

  • Sr. Member
  • ****
  • Posts: 314
Re: DDCSV1.1 4 Axis controller
« Reply #1003 on: October 29, 2020, 10:49:11 PM »
I can confirm the 3.1 factory firmware runs on the 1.1 hardware!!!

Key improvement: it actually TELLS you why it stopped ;-)

Sent from my SM-G892A using Tapatalk