Author Topic: Lathe Knife Tool and Boring Tool Sharpening  (Read 1232 times)

Offline Metalman

  • Jr. Member
  • **
  • Posts: 30
Lathe Knife Tool and Boring Tool Sharpening
« on: February 20, 2017, 05:06:23 PM »
Whilst it was my intention to publish one video a week, I have decided that I would like to bring the process to an earlier conclusion. Primarily, so that I can spend the summer without the need to spend time updating my website for each one, and advertising the video on around 15 forum.

Therefore, this week, I am making two videos available, also doing this until all the videos have been published in early May.
The videos this time are.

Lathe Knife Tool Sharpening and lathe Boring Tools Sharpening, links to both can be found here, 


Offline Biggles

  • Full Member
  • ***
  • Posts: 236
  • Country: gb
Re: Lathe Knife Tool and Boring Tool Sharpening
« Reply #1 on: February 21, 2017, 08:42:58 AM »
Nice idea Harold, personally I am working on a Jones & Shipman 3 way vice which I hope to use on my Clarkson grinder (when I put it into service). I also use a Tormek water stone system (250mm) for knives and tools at the moment.,11952.msg141619.html#msg141619