Author Topic: cnc to pwm servo bob  (Read 1734 times)

Offline BillTodd

  • Hero Member
  • *****
  • Posts: 885
  • Country: 00
  • Colchester Essex (where the lathes were made)
cnc to pwm servo bob
« on: November 06, 2017, 02:33:42 PM »
Inspired by joules' cnc thead, i thought I'd ask here about this…

Anyone know or have experience with a breakout board sthat will drive pwm servo amps (i.e.  takes input from mach or linuxcnc, outputs pwm control to servo amp and reads quadrature  from encoders)

I have  set of servo motors and amps (glentec) but no means to control them . 

The only thing i can find that might be suitable is. pico board fron the usa , but it is an expensive thing to experiment with.



Offline PK

  • Sr. Member
  • ****
  • Posts: 369
  • Country: au
Re: cnc to pwm servo bob
« Reply #1 on: November 06, 2017, 03:50:29 PM »
We use one of the Mesa boards with linuxcnc and our own amps on this:

A recent experience where I tried to build a servo system around some parts that I already had (in this case a couple of motors) taught me that it's cheaper just to buy a complete AC brushless kit .