Author Topic: Slitting Saw Arbor Material  (Read 648 times)

Offline DeanDK

  • Jr. Member
  • **
  • Posts: 15
Slitting Saw Arbor Material
« on: January 23, 2018, 07:59:03 PM »
Hello,

I'm purchasing some slitting saw arbors, and planning to make some arbors to suit.

I have a watchmakers lathe, so it will be WW thread collet. Is mild steel okay? I was thinking of making it from Silver Steel.

What are your thoughts on an ideal material for this tool?

Cheers,

Dean :wave:


Offline sparky961

  • Hero Member
  • *****
  • Posts: 839
  • Country: ca
Re: Slitting Saw Arbor Material
« Reply #1 on: January 24, 2018, 09:41:06 PM »
If you're looking for more toughness than mild steel can offer, I'd suggest 4140HT.  Unless you plan on hardening, which is not recommended for a tool arbour, there isn't much point to using silver (tool) steel.

That said, mild steel would likely serve you just fine without any trouble.