Home Base > Introductions
Hi from Germany
(1/1)
hdo27:
Hi all,
i'm from Germany and own a DIY cheap CNC machine i'm looking to replace
my current CNC setup based on Arduino GRBL and bCNC with a offline CNC
controller (DDCSV2.1)
Regards,
hdo
awemawson:
Hi HDO, welcome aboard, do let us know about your CNC machine and what you are doing with it.
Lots of support here on the forum
vtsteam:
Hi hdo, welcome! :wave:
krv3000:
hi and welcome
hdo27:
Thanks all!
I build a CNC machine out of plywood which was featured in the Germany edition of the Make magazine (2014).
The build was done in a local maker space nearby.
I also own a small german youtube channel featuring my machine :-)
https://www.youtube.com/channel/UCAxtKPCrl_JZVNRNzqVIZ6g
However it's been a while since i did anything with the machine :-(
Just bought a DDCSV controller for my machine and can't wait to play around with it ;-)
Regards,
hdo
Navigation
[0] Message Index
Go to full version