Author Topic: milling table for X1 mill  (Read 2643 times)

Offline jim

  • Sr. Member
  • ****
  • Posts: 439
  • Country: 00
milling table for X1 mill
« on: September 07, 2009, 12:44:59 PM »
not sure if this is in the correct place :scratch:

this is my bigger milltable for my mill head (X1) on my SIEG C4

its 10" x 10" and 16 mm thick ally plate, more than doubles the working area.

i've gone from spending more time trying clamp something, to loads of space!!! :clap:

even though this is a bit small (compared to the new mill, having power feed in X and Y is worth having

if i'd thought it through, i'd have never tried it