« previous next »
Pages: [1]   Go Down

Author Topic: Can Any One Help  (Read 4116 times)

Offline sbwhart

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 3530
  • Country: gb
  • Smile, Be Happy, Have Fun and Rock Until you Drop
Can Any One Help
« on: August 08, 2010, 05:08:07 PM »
At some point I'll be wonting to make a nameplate for my Loco, could any of you guys with a CNC or casting kit (loss wax) help me out with this.

Stew
Logged
A little bit of clearance never got in the road
 :wave:

Location:- Crewe Cheshire

Offline kvom

  • Hero Member
  • *****
  • Posts: 520
Re: Can Any One Help
« Reply #1 on: August 08, 2010, 05:33:34 PM »
I could give it a go.  Do you have a drawing of what you're thinking about?
Logged

Offline Gadget

  • Full Member
  • ***
  • Posts: 125
Re: Can Any One Help
« Reply #2 on: August 08, 2010, 08:00:10 PM »
Quote from: kvom on August 08, 2010, 05:33:34 PM
I could give it a go.  Do you have a drawing of what you're thinking about?
I'll be a backup for kvom
Dan
Logged

Offline sbwhart

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 3530
  • Country: gb
  • Smile, Be Happy, Have Fun and Rock Until you Drop
Re: Can Any One Help
« Reply #3 on: August 09, 2010, 02:02:27 AM »
Thanks Guys

I'll do a little research and knock up a CAD drawing.

Stew
Logged
A little bit of clearance never got in the road
 :wave:

Location:- Crewe Cheshire

lordedmond

  • Guest
Re: Can Any One Help
« Reply #4 on: August 09, 2010, 03:16:22 AM »
not quite the answer you asked for but if you want high quality name plates , head boards ect , or any plate for restored cars try 

http://www.loco-nameplates.com/


Diane is very good had a set done for the class 4 just told her the loco number and she supplied the correct shed plate ,build plates and tender cap plates all done in brass.

Stuart
Logged
Pages: [1]   Go Up
« previous next »