Author Topic: Making a Phase 2 QCTP 100 Series Tool Holder  (Read 3761 times)

Offline jamesemery728

  • Jr. Member
  • **
  • Posts: 8
Making a Phase 2 QCTP 100 Series Tool Holder
« on: January 22, 2011, 07:27:12 PM »
Hi All, I need to make another tool holder and I don't have any dove tail cutters. I know that the angle needed is 60 degrees but I am not sure of the diameter and the width that I need to order to make the dovetail for the 100 series. Since I don't own any dovetail cutters and have never ordered any, can someone give me some advice so that I order the correct size. Thank you in advance.

Offline 75Plus

  • Hero Member
  • *****
  • Posts: 624
  • Country: us
Re: Making a Phase 2 QCTP 100 Series Tool Holder
« Reply #1 on: January 24, 2011, 08:28:33 PM »
Have you seen CDCO's prices for series 100 or AXA holders?

http://cdcotools.com/

You can hardly buy the raw material for what they get for a complete holder.

Joe