Author Topic: Sieg Super C3 bearing change  (Read 20727 times)

Online John Rudd

  • Hero Member
  • *****
  • Posts: 2224
  • Country: gb
Re: Sieg Super C3 bearing change
« Reply #25 on: July 17, 2016, 03:49:08 PM »
Marco,
You would be better removing the bearing you have already installed on the spindle.....
Once removed, lightly polish the shaft journals so that the inner races are a tight-ish push fit...just make sure that when you polish them, they remain round not oval.... :dremel:

If you cannot remove the front bearing, make sure the rear bearing will move on the spindle journal, otherwise you wont be able to set the preload....
eccentric millionaire financed by 'er indoors
Location:  Backworth Newcastle

Skype: chippiejnr