What use shaper has on hobby work shop

[PekkaNF]

Thank you all. I have flu big time. Could not even go to day-job. I printed this so far and I'm following the link and leads.

Also noticed, that my location/nationality was not shown, put it there back. I appreciate all help and offers I got. Thank you.

Pekka.
Brrrr cold here, yesterday it was -30C outside, +19C inside and I had 38.3C. Nice stats.

[PekkaNF]

Right, It has been windy here, maybe I would need a lump of iron to hold down some scarce real estate floor on poor garage. However after rubbing my forehead with an empty wallet (I have a Ford to pay in instalments and it needed two visits to shop in last two weeks). I probably first should sort out HSS sharppening and make a serious try to it.

I got guided into right direction thanks to you all, but specially Fergus OMore and joshagrady, I'm reading the book. I have Ian Bradley The Amateur's Workshop.

Thank you Anthony and Rob for insight on use. I appreciate it.

loply:

PekkaNF

[AR1911]

You guys need to think on a higher plane!

One of my intentions is to build a magazine-fed can-crusher attachment