« previous next »
Pages: [1]   Go Down

Author Topic: Gear cutting with a shaper  (Read 6459 times)

Offline AdeV

  • Madmodder Committee
  • Hero Member
  • *****
  • Posts: 2434
  • Country: gb
Gear cutting with a shaper
« on: April 17, 2012, 01:12:48 PM »
Someone (guilty) had too much time on his hands today...


Found: One document explaining how to cut a true involute gear wheel of any number of teeth, using a shaper & a single cutter.

Now all I need is the shaper....

Logged
Cheers!
Ade.
--
Location: Wallasey, Merseyside. A long way from anywhere.
Occasionally: Zhengzhou, China. An even longer way from anywhere...

Offline mattinker

  • Hero Member
  • *****
  • Posts: 1316
  • Country: fr
Re: Gear cutting with a shaper
« Reply #1 on: April 17, 2012, 03:47:03 PM »
There was a long thread on the

http://finance.groups.yahoo.com/group/Metal_Shapers/

group about ten to twelve years ago, John Stevenson was involved, a very interesting thread!

Regards Matthew
Logged
Pages: [1]   Go Up
« previous next »