Author Topic: Removing chrome plate from brass  (Read 4470 times)

Offline Meldonmech

  • Hero Member
  • *****
  • Posts: 933
Removing chrome plate from brass
« on: September 13, 2012, 02:40:21 AM »
Hi,
     I have a quantity of brass fittings which are chrome plated, any suggestions on removal of the chrome and nickel.
     Reverse electrolysis is in my mind, may be using a 12 volt battery charger and a suitable electrolyte. The items would be     eventually recycled into new castings.

          Cheers David

Offline andyf

  • In Memoriam
  • Hero Member
  • *****
  • Posts: 1795
  • Country: gb
    • The Warco WM180 Lathe - Modifications
Re: Removing chrome plate from brass
« Reply #1 on: September 13, 2012, 03:42:09 AM »
I have heard that hydrochloric acid (muriatic acid) will remove chrome and any base layer of copper. I don't know what strength is needed, though. In the UK, it is sold (low stength) as brick cleaner for removing mortar smears.

If it eats chrome and copper, it will no doubt eat into the brass as well, but I don't suppose you will mind losing a bit if it is for castings.

An idea which might work: simply put the chromed items in your crucible and heat it up. Brass melts at around 900-950C. Chromium melts at 1857C, and is slightly denser than brass, so would remain solid and sink to the bottom, with a bit of assistance to flatten it down. Then pour off the brass.

Andy
 

Sale, Cheshire
I've cut the end off it twice, but it's still too short

Offline Meldonmech

  • Hero Member
  • *****
  • Posts: 933
Re: Removing chrome plate from brass
« Reply #2 on: September 14, 2012, 04:01:53 AM »
Hi Andy

Thanks  for the info. must give it a try.

          Cheers David