The Shop > Tools
Emco 150 mm Rotary Table - Needs some TLC!
Pete W.:
Hi there, all,
Some years ago, I was given this Emco 150 mm (6") rotary table.
I hadn't used it but I recently dug it out with a view to helping a friend with a job he was doing. In the course of looking it over, I realised that it needs some repair and refurbishment. It is complete with three division plates but I can't fit them because one of the fingers is stuck fast on its shaft. It does show edge-on in the photo but I've managed to get it right over the crease in the background paper!
I also managed to break the diecast operating handle on the detent spindle (see photo). [A plan is forming in my head as to how to make a replacement in mild steel.]
Please, please, does anyone out there have one of these tables? If so, I could use a bit of advice.
I had expected that there would be a fine adjustment knob and dial that could be fitted as an alternative to the division plate(s) and fingers - is there such an option?
I could also use any advice as to how to remove the stuck finger from its shaft.
John Rudd:
--- Quote from: Pete W. on June 07, 2013, 03:01:30 PM ---Hi there, all,
I was given this Emco 150 mm (6") rotary table.
One of the fingers is stuck fast on its shaft.
I could also use any advice as to how to remove the stuck finger from its shaft.
--- End quote ---
Spray it with release oil/WD40; leave for a day the see if it will move...
If not, try heat from a hot air gun to expand it where it sits on the shaft...
Maybe a little persuasion from a 2/3 leg puller?
krv3000:
simpel to macka new handel mack it in two bits and weld the lever on be very cerful on dismantiling it as spers for emco stuff is out of this world i no as i have a emco compact 8 lathe they wonted £80 for a fowerd and revers swich i got one for £10 and its made in the uk
Pete W.:
Hi there, John and Bob,
Thank you for your posts.
Bob, I'll probably silver solder as I don't have welding equipment.
The challenging bit is drilling the cross holes in the replacement boss so they line up with the roll-pin hole in the detent shaft.
One problem I'm having at present is that when you use the detent, the worm has to be moved out of engagement with its wheel and vice versa. I can't figure out how it's held in either the engaged or disengaged position.
My table has its locking levers beneath the table - the tables shown on the Pro Machine Tools web-site have their locking levers on the upper surface of the body.
lockstocknbarrel:
Hi Pete,
I have one, I may be able to answer questions :Doh:.
Just Send me a Private email.
Kindest Regards
Beagles
Navigation
[0] Message Index
[#] Next page
Go to full version