« previous next »
Pages: [1]   Go Down

Author Topic: Blow outs in gunmetal castings  (Read 4214 times)

Offline steamup

  • Jr. Member
  • **
  • Posts: 63
  • Country: england
Blow outs in gunmetal castings
« on: April 26, 2014, 01:51:26 AM »
I have a cylinder casting which has two blow hollows  :(.
Is it possible to fill these?
Logged

Offline Joules

  • Hero Member
  • *****
  • Posts: 1271
  • Country: gb
Re: Blow outs in gunmetal castings
« Reply #1 on: April 26, 2014, 06:10:28 AM »
 JB Weld is your friend, just fixed a couple of Chinese casting defects on a compound table slide way.  In my case the JB Weld was to stop anymore debris working its way onto the bearing surfaces I had just scraped.
Logged
Honour your mentors, and pay it forward.

Offline steamup

  • Jr. Member
  • **
  • Posts: 63
  • Country: england
Re: Blow outs in gunmetal castings
« Reply #2 on: April 26, 2014, 07:37:19 AM »
Thanks Joules isnt the internet great :)
Logged
Pages: [1]   Go Up
« previous next »