MadModder
Gallery, Projects and General => Neat Stuff => Topic started by: andyf on December 24, 2011, 07:34:55 PM
-
A Reprap printed wobbler engine:
&feature=youtu.be
Andy
-
thats pretty neat, I assume though you have done a little machining on the bore and piston though?
-
It's not mine, Shipto. Just a vid which was mentioned on another forum. I don't want to get involved with 3D printers; the 2D one attached to my computer gives me enough trouble.
I've no idea how accurate Repraps and similar devices are, but like you I suspect that some machining comes into it. And on a plastic engine, friction and the heat it creates must be a problem.
Andy
-
Ah sorry thought you had made it.
I looked into the reprap a while back and from what i saw the finish would not be good enough to simply fit a piston into a bore in fact looking at that video again I see some sharp edges on most of the bits which I kinda doubt could have been JUST printed.