MadModder
Gallery, Projects and General => The Design Shop => Topic started by: Swarfing on February 08, 2011, 04:50:23 PM
-
Thought i would drop this in as i thought was a good idea even though not new.
http://bbs.homeshopmachinist.net/showthread.php?t=43645
-
That might come in handy soon :thumbup:
Thanks for sharing.
-
This is perfect timing for me...
Many thanks
Eric
-
Hello all,
I'd just like to add my $0.02 on this method - just recently had cause to use it as the Z axis on my Maximat V10P milling head stripped out the unusual thread on the nut - just over 0.55" X 16 TPI (evidently a unique acme used by Emco Maier). With replacements non-existent, it was either come up with a way to replace it entirely, and in all probability with a 5/8"X8 Acme, or make a new nut.
In desperation I tried the acetal method and so far it is working perfectly, in many ways, better than the original, but worn, nut. I highly recommend this method if one cannot get or make a replacement nut.
Best,
Mike
-
I do use delrin/ acetol nuts on my CNC router but have always cut the threads with a home made tap. this has always been satisfactory but i must admit this method is a better approach to it. The only issue as to have a sacrificial piece of the screw, in the long term though to make a batch up is a lot cheaper.
-
Mike,
Do you have any pictures of the nut you made?
Eric
-
Mike it was probably a 14mm leadscrew and may well have been the metric 30degree trapizoidal form rather than 29 degree acme. I think thats what my old Ecomat 8.6 used. They would have used the same 14mm dia but a metric pitch on the metric machines.
J
-
Sorry Eric i don't and it is fitted to the machine.
-
Thanks for the link. That could be an easy fix for a lot of tools. I wonder how much pressure it can take?