MadModder

Home Base => Introductions => Topic started by: hdo27 on July 09, 2018, 03:10:30 AM

Title: Hi from Germany
Post by: hdo27 on July 09, 2018, 03:10:30 AM

Hi all,

i'm from Germany and own a DIY cheap CNC machine i'm looking to replace
my current CNC setup based on Arduino GRBL and bCNC with a offline CNC
controller (DDCSV2.1)

Regards,

hdo

Title: Re: Hi from Germany
Post by: awemawson on July 09, 2018, 05:13:31 AM

Hi HDO, welcome aboard, do let us know about your CNC machine and what you are doing with it.

Lots of support here on the forum

Title: Re: Hi from Germany
Post by: vtsteam on July 09, 2018, 12:00:45 PM

Hi hdo, welcome!  :wave:

Title: Re: Hi from Germany
Post by: krv3000 on July 09, 2018, 05:20:05 PM

hi and welcome

Title: Re: Hi from Germany
Post by: hdo27 on July 10, 2018, 02:49:02 AM

Thanks all!

I build a CNC machine out of plywood which was featured in the Germany edition of the Make magazine (2014).
The build was done in a local maker space nearby.

I also own a small german youtube channel featuring my machine :-)

https://www.youtube.com/channel/UCAxtKPCrl_JZVNRNzqVIZ6g (https://www.youtube.com/channel/UCAxtKPCrl_JZVNRNzqVIZ6g)

However it's been a while since i did anything with the machine :-(

Just bought a DDCSV controller for my machine and can't wait to play around with it ;-)

Regards,

hdo