MadModder
Home Base => Introductions => Topic started by: scottmk1 on September 14, 2013, 07:34:56 AM
-
Hi, just joined the forum after finding it by chance. I have an interest in all sorts of work shop equipment and activities, but mainly car and bike related stuff. I have a Boxford 11-30 lathe and I have a question about making a 5mt - 3mt reducing bush fit into the headstock spindle for mounting centres etc, but I will start another thread for that one.
Scott
-
Scott,
Welcome aboard, you'll find lots of help here.
5 -> 3 mt bushes are widely available and not too expensive, I'd question if it's worth making one:
These can be used direct - or cut down with an angle grinder:
http://www.ebay.co.uk/itm/One-3-5-Morse-Taper-Drill-sleeve-fully-H-G-/281144780153?pt=LH_DefaultDomain_3&hash=item417588e579
or these people will sell you the correct short bush:
http://www.gandmtools.com/
and
http://www.homeandworkshop.co.uk/
Good luck,
Andrew
-
Hi Andrew, thanks for the reply, I have a 5mt -3mt bush already. The headstock spindle has this taper No.4.5 ASA.B5.10 and Boxford want nigh on £100 for a bush! I will try those links you posted and see where I get.
-
Hi Scott
Welcome to the collective :borg:
Tell us about the ca and bike stuff.
Eric
-
faur aboots dae ye cum fae in Scotland?
-
Hi daz, I'm from fife how about yourself?
-
Fit like Scott
Welcome to the group
Another Scottish lad
Alb (In Aberdeen)
-
Hi daz, I'm from fife how about yourself?
Just north of you neebs, just outside Perth. Depending whereabouts in the kingdom you are, you might be quite close. Spent a lot of time round Fife, playing rugby and working, think I got my first broken nose at the Howe! I hope yer no fae cupar!!!
-
No I'm no fae cupar, half way between Cupar and Glenrothes so not too far away from the Perth area.
-
Wot diddy sigh?
Jim
-
hi and welcume
-
Hi Scott welcome to the forum , as far as the planet goes I am not too far from you, Newcastle upon Tyne ( I still would not fancy walking it mind :lol: ) I think you lads over the border sometimes refer to us Geordies as ' Scottsmen with their brains kicked oot ' :clap: . Hope to see some posts of your projects .
:beer: Cheers Mick.
-
No I'm no fae cupar, half way between Cupar and Glenrothes so not too far away from the Perth area.
Hi Scott,
Ye canny be faur awa' fey me then...
I'm aboot haufway between Cupar and Glenrothes tae!
In the hame toon o' the Singing Kettle...
So where are you?
Regards,
neebs
-
hello another lad just joined fae peterhead
-
hi scott cant send pm because your inbox is full
-
Hi Scot
Welcome to Madmodder
Cheers David
-
Hi roughcaster, inbox now cleared mate.
-
Sorry I missed this,first time around -- Anyway, Welcome Scott! :beer:
-
A year late I know but did anyone figure out where to get the bush? I've got a Boxford STS with the same missing headstock reduction sleeve. Strangely enough I'm in Dundee! Cheers!