MadModder

The Shop => Tools => Topic started by: Metalman on February 07, 2017, 03:30:33 PM

Title: Small Boring Head
Post by: Metalman on February 07, 2017, 03:30:33 PM
My video this week is for a small boring head which I made to suit my lathe milling head ( http://www.homews.co.uk/page158.html ) It should also be suitable for any of the small milling machines, for which to my knowledge, there are few, if any, suitable commercial heads.

A link to the video can be found here,  http://www.homews.co.uk/page199.html

Next will be a series of  “how to” videos  showing how to use my grinding rests for various sharpening tasks, typically, end mills (both edges), boring tools and slitting saws.

Harold
Title: Re: Small Boring Head
Post by: Will_D on February 08, 2017, 08:14:27 AM
Next will be a series of  “how to” videos  showing how to use my grinding rests for various sharpening tasks, typically, end mills (both edges), boring tools and slitting saws.

Harold
Thanks Harold, my grinding rest and accouterments are nearly completed